System-sensor BEAM200 and BEAM200S Manuel d'utilisateur télécharger pdf (Page 10)

D400-74-00 10 I56-2289-005R

Blinks output by Yellow LED and Remote Trouble Output

once the device has passed a local remote test:

Percent The Detector Has Drifted Number Of Blinks Output

<10% None

<20% 1

<30% 2

<40% 3

<50% 4

<60% 5

<70% 6

<80% 7

<90% 8

<100% 9

Modes *Red

See Note

Below

Yellow and

Remote Trouble

Output

*Green

See Note

Below

Remote

Alarm

Output

Dual Digital Display Initiating means Comments & Troubleshooting

Tips

Normal Off Off Blink Blink Off Successful completion

of initialization or

detector reset

Alignment Off On Blink Blink On, Relative amount

of signal 0-99, or – if

automatic gain resetting,

or Lo if signal is too low

Alignment Switch

Alarm On Off Off On Off Smoke, Test Filter,

RTS451 or RTS151

Test Stations

Trouble-Drift

Comp Elevated

Signal

Off 3 Quick Blinks Blink Blink Off Long Term Drift

Reference Out of

Range

• Sunlight into detector or reector.

• Re-Align detector.

Trouble-Drift

Comp Reduced

Signal

Off 2 Quick Blinks Blink Blink Off Long Term Drift

Reference Out of

Range

• Clean detector and reector.

Trouble-Signal

Over Range

Off 2 Quick Blinks Blink Blink Off Increase of Reflected

Signal

• Inspect line of sight between

detector and reector for

reective objects in the pathway.

Trouble-Beam

Blockage

Response

Off 4 Quick Blinks Blink Blink Off Beam Blockage • Remove blockage.

• Faulty unit.

Initialization-

Power on

Off Blink until

complete

Blink Blink Off Apply Power from

discharged state.

Initialization-

alignment exit

Off Blink until

complete

Blink Blink Off Depressing RESET

switch after alignment

Local Test

(BEAM-200S)

Pass Result

On Blinks out amount

of drift used

Off On Off Panel or RTS451/KEY

or RTS151/KEY

Remains in alarm until reset or

time-out

Local Test

(BEAM-200S)

Fail Result

Off On until reset or

time-out

Blink Blink Off Panel or RTS451/KEY

or RTS151/KEY test

input

Remains in fault until reset or

time-out

Local Test

(BEAM-200)

Fail

Off On until reset or

time-out

Blink Blink Off Panel or RTS451/KEY

or RTS151/KEY test

input

Remains in fault until reset or

time-out

Local Test

(BEAM-200)

Pass Result

On Blinks out amount

of drift used

Off On Off Panel or RTS451/KEY

or RTS151/KEY

Remains in alarm until reset or

time-out

Note: Green and Red LEDs are controlled by the control panel.

APPENDIX I. OPERATION MODES AND TROUBLESHOOTING GUIDE:

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Commentaires sur ces manuels

Pas de commentaire

System-sensor BEAM200 and BEAM200S Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement System-sensor BEAM200 and BEAM200S